Panasonic Digital Business System - Programming Manual
April 1997
Issue 15
122
L
L
C
C
R
R
DBS LCR is designed to take up to 7 indirect access networks in addition to a directly connected
network. In default programming, network 1 is set up for Mercury Communications and network 8
is set for access to BT. When LCR is used, the DBS will select the cheapest network based on the
programming options set here.
LCR programming is password protected and requires an access code to be entered before the
programming mode is enabled. The default setting for this password is 0000.
Use of LCR
2.x
[0:NOT USE 1:USE]
FF10-(PASSWORD)#-1#-1#-(0 or 1)#
0#: LCR is not used
1#: LCR is used
Set this to enable LCR in the system.
LCR programming password
2.x
[SET 4DIGIT DATA]
FF10-(PASSWORD)#-1#-2#-(0000-9999)#
[CONF]: The password is 0000
(0000-9999): Required password
The password to access LCR programming can be changed. This code cannot be confirmed when
it is once registered but can be defaulted and re-entered.
NOTE: If the password is changed and forgotten the system must be completely reset to
regain access to LCR programming.
Pause after network access code
2.x
[LCR PAUSE TIMER]
FF10-(PASSWORD)#-1#-3#-(1-15)#
1#: 1 second
2#: 2 seconds
3#: 3 seconds
4#: 4 seconds
5#: 5 seconds
6#: 6 seconds
7#: 7 seconds
8#: 8 seconds
9#: 9 seconds
10#: 10 seconds
11#: 11 seconds
12#: 12 seconds
13#: 13 seconds
14#: 14 seconds
15#: 15 seconds
After sending the network access code, an automatic pause time is provided to ensure that
dialling is delayed until the carrier’s secondary dial tone is received.
