Panametrics CGA 351, Руководство пользователя, Страница: 25 / 119

CGA 351 User’s Manual 19
Chapter 3.
Configuration Options (cont.)
Note: The
[0:Analog Output]
,
[2:Alarm-1]
,
[2:Alarm-2]
,
[2:Alarm-3]
and
[2:Alarm-4] options
are also available in the
above box.
To select the desired output(s) from the previous list box, complete the following steps:
1. Use the [

] and [

] keys to highlight a specific output. For this example, make sure that [0: Display] is selected
as one of the outputs.
2. Use the [

] and [

] keys to select “Add” or “Remove” and press the [ENTER] key to change the status of the
selected output. An output is selected if an asterisk (*) appears to its left.
3. When all of the desired outputs have been selected, use the [

] and [

] keys to select
“OK” and press the
[ENTER] key.
Notice that the newly configured display shows the
slot number and the input parameter on the top line, and the
current
live value along with the unit type are displayed in the center of the screen.
Note: See “The [Opt-User] Menu” on page 46 for instructions on how to adjust the display contrast.
Table 9:
From 1: Cfg Ox..pcnt A list of the available output
devices is shown. Follow the
instructions below to select
the desired outputs.
*0: Display
*0: Fault Alarm
Add Remove OK Cancel
POWER ESC ENTER
Table 10:
1 Oxygen Press [ESC] four times to
return the display to the
actual set configuration.
2.71 ppm
POWER ESC ENTER