Panametrics CGA 351, Руководство пользователя, Страница: 52 / 119

Chapter 4.
46 CGA 351 User’s Manual
4.1.7 The [Opt-User] Menu
After entering the
User Program, access the
[Opt-User] submenu to perform the following operations:
• setting the fault alarm type
• setting up the analog output
• adjusting the display contrast
• setting the display backlight
• configuring the serial port
Proceed to the appropriate section for specific instructions on the topic of interest.
4.1.8 Setting Fault Alarm Type
To set up the fault alarm, enter the
User Program as described on page 27 and proceed as follows:
Note: The [Lock All] and [Versions] options are also available in the above list box.
Note: The [Backlight] and [Comm] options are also available in the above list box.
Table 71:
Cfg Cal Opt Disp Use the [

] and [

] keys to
select [Opt] and press
[ENTER] .
POWER ESC ENTER
Table 72:
Cfg Cal Opt Disp A list of the available options
is shown. Use the [

] and [

]
keys to select [User] and
press [ENTER] .
User
Setup
Lock Menus
POWER ESC ENTER
Table 73:
User Use the [

] and [

] keys to
select [Fault Alarm] and
press [ENTER] .
Fault Alarm
Analog Output
Contrast
POWER ESC ENTER