21
ENGLISH
Autodos M
MA60-10E
ENGLISH
Autodos M
MA60-10E
Systems configuration
General
In the cases where another setting than the pre-programmed factory settings is desired, configuration mode needs to be
entered. To enter configuration mode, authorisation level 2 must be activated with a code and calibration mode shall be activated.
(No access code is programmed in factory settings.)
The systems configuration consists of two parts:
Basic functions
with shared settings and
Electrode specific configuration
for the respective channel settings.
Enter configuration mode
Press the button
Code
[10], enter the opening code. Release the button. The diode “
Code
” flashes as confirmation.
Press the button
Cal.
[0] to enter configuration mode. The diode “
Active
” illuminates as confirmation.
There are different configuration modes depending on the Autodos model used, but all have a common mode where entered
settings affect the basic functions and one mode with specific settings for the respective electrodes.
Configuration of basic functions
Proceed as follows to configure all channels:
Model Autodos M3 - free chlorine, redox, pH:
press the buttons
Set acid
[11] +
Reset
[15].
On all other models:
press the buttons
Function
[11] +
Reset
[15].
This is indicated via the text “
SEt UP
” and the “
Off
” and “
Auto
” LEDs being unlit.
To exit configuration, press the
Cal.
button [0] or scroll past the last line.
The following can be changed in the common configuration; see relevant model pages 22–26.
Autodos M1
Select the line for which you want to change the setting on by pressing
Alarm high
[12] or
Alarm low
[14] button.
When the button
Alarm high
[12] or
Alarm low
[14] is held depressed, the display shows the actual line number.
When the buttons are released, the display shows either a text indicating which setting can be changed or a numeric value.
To change a text or value, press ↑ or ↓ .
The selected configuration type is indicated via one of the following texts: ”
SEt
”, ”
FCL
”, ”
ACi
” or ”
bAS
” depending on variant.
Autodos M2 and M3
Select the line for which you want to change the setting on by pressing ↑ or ↓ under display 2.
When the arrow button is held depressed, display 3 shows the actual line number and display 2 shows the selected configu-
ration type (e.g. “
SET
” “-01”).
When the buttons are released, display 2 shows a text indicating which setting can be changed and display 3 shows a text or
a numeric value.
To change a text or value, press ↑ or ↓ under the relevant display.
