PACOM 16-Channel, Руководство пользователя

Страница: 32 / 84

User’s Manual
24
NOTE: Entering the ID and Password and highlighting OK reads the current IP address of the DVR configured
by the ADSL network.
If the DVR is configured for DHCP or an ADSL network, the IP address of the DVR might change whenever
the unit is turned on.
Highlight the
DVRNS
tab, and the DVRNS screen displays.
Highlight
Use DVR Name Service
and press the button
to toggle between On and Off.
NOTE: The DVRNS (DVR Name Service) allows the DVR to
use Dynamic IP addresses for remote connection.
When this feature is On, you can access your DVR
remotely using the DVR name instead of its IP
address. For the DVRNS feature, the DVR should
be registered on the DVRNS server.
Highlight the box beside
DVRNS Server
and press the
button. A virtual keyboard appears allowing you to enter the
IP address or domain name of the DVRNS server.
Figure 23 — DVRNS setup screen.
NOTE: You will need to get the IP Address or domain name of the DVRNS Server from your network administrator.
You can use the domain name instead of IP address if you already set up the DNS Server when setting
up the LAN.
Highlight the box beside
Port
and press the button. Set the port number of the DVRNS server using the
Up
and
Down
arrow buttons to increase or decrease the numbers.
Highlight
Use NAT
and press the button to toggle between On and Off.
NOTE: When using the NAT (Network Address Translation) device, refer to the NAT manufacturer’s instructions
for the proper network settings.
Highlight the box beside
DVR Name
and press the button. A virtual keyboard appears allowing you to enter the
DVR name to be registered on the DVRNS server.
Highlight the
Check
box and press the button to check whether or not the name you entered can be used.
NOTE: The DVR name you entered should be checked by selecting Check, otherwise the DVRNS changes will
not be saved.
When entering no name or a name already registered on the DVRNS server, an error message displays.
Highlighting
Save
and pressing the button registers the DVR on the DVRNS server. Proper DVRNS settings will
display the help desk information of the DVRNS server in the box beside
Help Desk
.
Highlight the
RTSP
tab, and the RTSP setup screen displays.
Figure 24 — RTSP setup screen.
Highlight
Enable RTSP
(Real-Time Streaming Protocol) and
press the button to toggle between On and Off. You will
be able to change the settings if Enable RTSP is enabled.
Highlight the box beside
RTSP Port
and press the button.
Set the port number of the RTSP server obtained from your
system administrator.
Highlight the box beside
RTP Start Port
and press the
button. Set the start port number of the RTP server obtained
from your system administrator.
Highlight the box beside
RTP End Port
and press the
button. Set the end port number of the RTP server obtained
from your system administrator.