Pacific energy FP25, Инструкция по сборке, установке и эксплуатации, Страница: 7 / 40

Baffle:
• Some warping of the baffle is normal(up to 1/4” or .65cm).
• Replace if the baffle has permanent warping greater than this or has cracking or breakage.
• Please contact your Dealer if you experience any of the damage listed above. Continuing to operate your
fireplace with broken parts may accelerate damage to other parts
• and may void your warranty.
Baffle Removal
See "Baffle Removal" on page 13
The baffle should only be removed when chimney is being cleaned.
DO NOT OPERATE WITH BAFFLE ASSEMBLY OR INSULATION REMOVED.
NOTE: AFTER YOU REMOVE THE BAFFLE, ALWAYS COVER THE BAFFLE AIR TUBE THAT PROVIDES
AIR TO THE BAFFLE. THIS PREVENTS DEBRIS FALLING DOWN THE TUBE.
Secondary Air Box Cleaning
1. The secondary air box is located on the bottom rear of the fireplace and can be cleaned by removing the
small access panel on the bottom of the firebox just in front of the baffle supply tube. Remove the bricks
to expose the access panel, then remove the 2 screws holding the access panel.
2. Use a vacuum to suck out any debris.
3. Replace the access panel. Replace the gasket if needed.
*
MAKE SURE THE GASKET IS IN GOOD SHAPE AND POSITIONED CORRECTLY. IF IT IS DAMAGED
THEN IT MUST BE REPLACED.
Glass Cleaning
If glass becomes darkened through slow burning or poor wood, it can readily be cleaned with fireplace glass
cleaner when the fireplace is cold. Never scrape with an object that might scratch the glass. The type and
amount of deposit on the glass is a good indication of the flue pipe and chimney buildup. A light brown dusty
deposit that is easily wiped off usually indicates good combustion and dry, well-seasoned wood and there-
fore relatively clean pipes and chimney. On the other hand, a black greasy deposit that is difficult to remove is
a result of wet and green wood and too slow a burning rate. This heavy deposit is building up as quickly in the
chimney.
7
100001385_071118-40
FP25