4. Do not load fuel to a height that exceeds 7 1/2" from the firebox floor or in such a manner that would be
hazardous when opening the door.
5. For extended or overnight burns, unsplit logs are preferred. Remember to char the wood completely on
"High" setting before adjusting air control to the "Low" setting for overnight burn.
Curing of the paint finish
See Stove Bright user guide. When burning your stove for the first 2-3 times it is very important that the room
be well ventilated. Open all windows and doors. Smoke and fumes caused by the curing process may cause
discomfort to some individuals.
Health Warning.
The smoke from the curing process displaces oxygen. Small children, elderly folks and persons with existing
breathing problems should vacate the area during the hot burn to avoid the discomfort of lost oxygen. The
smoke is primarily Carbon Dioxide, and therefore non-toxic but uncomfortable.
WARNING: Always keep loading door closed when burning. This heater is not designed for open door
burning.
WARNING: No alteration or modification of the combustion air control assembly is permitted. Any
tampering will void warranty and could be very hazardous.
WARNING: Do not use grates or andirons to elevate the fuel. Burn directly on the fire bricks. Replace
broken or missing bricks. Failure to do so may create a hazardous condition.
Restarting After Extended or Overnight Burns
1. Open door and rake hot embers towards the front of the heater. Add a couple of dry, split logs on top of
embers, close door.
2. Adjust air control to high and in just a few minutes, logs should begin burning.
3. After wood has charred, reset air control to desired setting.
4. To achieve maximum firing rate, set control to “High” position(all the way to the left). Do not use this set-
ting other than for starting or preheating fresh fuel loads.
Over Firing
DO NOT OVERFIRE THIS HEATER: Attempts to achieve heat output rates that exceed heater design
specifications can result in permanent damage to the heater and chimney.
Over firing can be caused by operating the unit with the door open, damage to door gaskets allowing excess
air to enter the firebox, the use of kiln dried lumber, mill ends or paper waste and prolonged or continual use
on a high burn setting.
11
100001385_071118-40
FP25
Содержание FP25
Страница 39: ...39 100001385_071118 40 FP25...