Pacific energy FP25, Инструкция по сборке, установке и эксплуатации, Страница: 34 / 40

Problem Cause Cure
Glass is Dirty 1. Wood is wet - Use dry wood
2. Turning down air control - Do not turn down until
or damper too soon a) there is a good bed of coals
b) the wood is charred
3. Draft too low - Improper chimney height and / or diameter
- Chimney plugged or restricted, check flue
- Provide outside air for combustion
4. Door gasket leakage - Replace gasket
- Check latch
Excessive Creosote Buildup - See 1, 2, 3, above.
Low Heat Output 1. Wood is wet - Use dry wood
2. Fire too small - Build a larger fire
3. Draft too low - Chimney plugged or restricted, inspect
and clean
Won’t Burn Overnight 1. Air control is set too high - Set control lower
2. Not enough wood - Unsplit wood is preferred for overnight burns
3. Draft too high - Excessive chimney height and/or diameter,
See "Proper Draft" on page 12.
Stove Won’t Burn 1. Combustion air supply - Check outside air supply for obstruction
blocked - Check that room air cover is removed
2. Draft too low - Chimney plugged or restricted, inspect and
clean
- Chimney oversized or otherwise unsuitable,
consult Dealer
Troubleshooting
34
100001385_071118-40
FP25