©2009 Overhead Door Corporation
Part Number 37027500123 02/26/2010 REV. 1
9
1.
READ AND FOLLOW ALL SAFETY, INSTALLATION
AND OPERATION INSTRUCTIONS.
(If you have
questions or do not understand an instruction,
call the Overhead Door Corporation or an
authorized Overhead Door Dealer.)
2. Install only on a properly balanced
sectional
garage door. An improperly balanced door could
cause severe injury. Have a trained door system
technician make repairs or adjustments to cables,
spring assemblies, and other hardware
before
installing the opener.
3. Remove all ropes and remove or make
inoperative all locks connected to the garage
door before installing opener.
4. Where possible, install the door opener
7 feet
or more above
the floor. For products having
an emergency release, mount the emergency
release 6 feet above the floor.
IMPORTANT INSTALLATION INSTRUCTIONS
CAUTION
WARNING: To reduce the risk of severe injury or death:
5.
Do NOT
connect the opener to source of power
until instructed to do so.
6. Locate the Wall Control:
• Within sight of door,
• At minimum height of 5 feet so small
children are not able to reach it, and
• Away from all moving parts of the door.
7. Install the
Entrapment WARNING Label
next to
the Wall Control in a prominent location. Install
the Emergency Release Tag on or next to the
emergency release.
8. After installing the opener,
the door must
reverse within 2 seconds
when it contacts a
1-1/2 inch high object (or a 2 x 4 board laid flat)
on the floor.
OPENER ASSEMBLY
FOR HELP-1.800.929.3667 OR WWW.OVERHEADDOOR.COM
NOTE: Please follow ALL instructions in their NUMBERED sequence. Use wall control and safety sensors
provided with this unit. Do NOT substitute wall control or safety sensors.
1
RAIL ASSEMBLY: Use a clean, fl at surface.
WARNING
To reduce the risk of injury to persons or
damage to property - Use this opener only
with sectional doors.
CAUTION
Do NOT
run until opener is fully assembled and
instructed to do so.
Clear a workspace area to unpack and organize box
and contents for assembly.
1.
There are 4, or more, boxes inside the carton. Each
box is numbered 1 - 4. Note that some openers
will contain the same parts and be packaged
with fewer boxes.
Carefully remove the three
internal boxes (Labeled #1, 2, and 3) and place
them on the floor for easy access (Fig. 1-1).
These boxes contain assembly parts and the
contents are organized by assembly tasks. For
quick reference inside the lid of each box there is
a label illustrating the components inside.
2.
Remove the motor power head and place it
on the floor for later use. Remove box #4 and
place it on the floor for later use.
FIG. 1-1 Internal boxes
clevis pin & cotter pin
bolts &
nuts
Insulated
Staple
Control
Wire
Wall Control
Door Bracket
Door
Bag 4
Bag 6
Bag 7
Bag 5
Box Label Example
