OSYPKA PACE 203H, Инструкция по эксплуатации, Страница: 36 / 139

PACE 203H – Instructions for Use
36 / 139 5I-17-016X-B-20
Note
: In case of a change from a single
to a dual chamber mode or from one
chamber mode to another chamber
mode (for instance VVI
→ AAI), the last
used parameters are adopted. If the
Turn-on program (see chapter 1.1.1),
has been re-defined to a single chamber
mode, in case of a first change of such
kind, the parameter set will be comple-
mented from the standard program of
the new mode.
The enabling of the atrial trigger function
in the AAI and DDD modes is described
in chapter 9.12.5.3.
A non-pacing mode (0D0) is accessible
by pressing the key labeled
Pause
(see
chapter 1.1).
Note
: A standard program can be stored
for each primary mode. These standard
programs may be defined by the user
(see chapter 1.1).
Note
: If conflicts (because of abnormal
settings) occur as a result of a mode
change, PACE 203H will make use of its
Automatic setting feature to solve the
problem (see chapter 9.22.7 and 9.9).
9.8 Adjustment of Rate,
Stimulation Amplitude,
Sensitivity and A-V Delay
One rotary dial is assigned to each of the
parameters. Table 11 shows the function
of each dial.
Dial Function
RATE
Basic rate
A-SENSE
Atrial sensitivity
A-STIM
Atrial stimulation
amplitude
A-V DLY
Atrio-ventricular delay
V-STIM
Ventricular stimulation
amplitude
V-SENSE
Ventricular sensitivity
Table 11: Rotary Dial functions, listed in
order from top to bottom
The actual values of the parameters and
the corresponding bar diagrams indicat-
ing signal intensity or magnitudes, are
located in the upper display, which is
always turned on. These bar diagrams
indicate the set value within its range.
In order to change a parameter or pa-
rameters, the dials must be unlocked by
pressing the key
Unlock/Lock
(if
PACE 203H is not yet unlocked).
Rotating the rate, amplitude, or A-V
Delay dials clockwise increases the
parameter value. In contrast,