ORKEL Dens-X Compactor, Руководство пользователя

Страница: 94 / 142

4. Drain until empty.
5. Clean the oil spill.
6. Mount the new filter.
7. Dispose with the old filter according to environmental regulations.
IMPORTANT: Always use original parts when changing filter.
Changing gear oil
For main gear, feed hopper, elevator and wrapping table:
1. Place an empty container beneath the drain hole.
2. Remove the drain plug.
3. Drain until empty.
4. Clean the plug.
5. Clean up the oil spill.
6. Reinsert the plug (replace sealing if necessary).
7. Refill with Shell Omala S2 220.
8. Check the oil level.
Sub-conveyor gear
1. Remove the gear from the compactor.
2. Rotate (drain plug down).
3. Place an empty container beneath the drain hole.
4. Remove the drain plug.
5. Drain until empty.
6. Clean the magnetic plug.
7. Mount the gear in its original position.
8. Refill with Shell Omala S2 220.
9. Reinsert the plug.
7.15 WELDING AND GRINDING
DISCLAIMER: Changes made to the frame may invalidate warranty and homologation standards. By doing so
you may forfeit warranty claims. Any changes to the frame or machine should be avoided if possible.
All welding, drilling and other work done on the frame, must be carried out with great caution.
7.15.1 Precautions when welding
IMPORTANT: The control unit must be disconnected before welding.
Place the ground connector as close to the welding point as possible. Observe excessive temperatures.
NOTE: After grinding/cutting/welding, repaint the areas in order to avoid corrosion.
7 MAINTENANCE AND MECHANICAL ADJUSTMENTS 94