ORKEL Dens-X Compactor, Руководство пользователя

Страница: 31 / 142

3.7.2 Film cutter settings
The opening and closing speed of the film cutters must be set correctly. If their speed is too high, the wrap-
ping film might be damaged instead of neatly cut when the wrapping arms stop. The film cutters speed,
left (valve P4) and right (valve P5), may be reduced by turning the valve clockwise. Both cutters should be
equally set. The cutters should move softly.
Default setting: Close the valve and then open 1/2 turn.
Figure 3.6 : Film cutter valves
Setting the speed: Turning the valve clockwise decreases the speed. Turning the valve counterclockwise
increases the speed. Adjusting the height of the cutters is normally not necessary. The film should lay on
the middle of the cutter when cut.
Film cutter rollers: Film cutter, upper position: Both rollers must roll freely. Film cutter, lower position: The
outer roller should be kept locked. This is in order to hold the film so that it is cut, not ripped. Make sure
that the knife is centred between the two rollers. Straighten the knife, if necessary. See
Figure 3.7
Figure 3.7 : Film cutter rollers
3 SETTINGS AND HYDRAULIC ADJUSTMENTS 31