ORKEL Dens-X Compactor, Руководство пользователя

Страница: 38 / 142

3. Connect the hydraulic hoses to the tractors hydraulic take outs.
4. Connect the PTO drive shaft according to the manufacturers instructions. The PTO drive shaft pro-
tection shall be intact and secured in both ends. Read the safety guidelines enclosed with the PTO
drive shaft.
5. Pull the nylon ropes to disengage the drawbar transport safety lock.
6. Swing the flexible drawbar all the way out to either side (see section 3.8.1 "Flexible drawbar" ).
7. Engage the main power switch to activate the compactor battery pack ( section 4.2.8 "Electrical
power source" ).
8. Start levelling the machine with the hydraulic jack stands, left- and right rear (lever 1 and 2, see
section 4.2.4 "Lever list" ). Use sight glasses mounted on the frame to verify levelling.
Figure 4.1 : Tractor lineup. Ensure that the tractor is on the same line as the PTO shaft.
IMPORTANT: Flexible drawbar (tilting part) has to be in float position.
9. Continue levelling the machine with hydraulic jack stand, left- and right front (lever 7 and 8).
10. When levelling is done, operate the left and right part of the feed hopper OUT (lever 3 and 4). It is
important that both feed hopper parts are moved all the way out to their end position.
11. Sufficient clearance must be achieved between the hopper halves before lowering to down position
(limit switch active when sufficient). User resources are available at www.orkel.com
12. Lower the left part of the feed hopper to DOWN position (lever 5).
13. Lower the right part of the feed hopper to DOWN position (lever 6).
14. Lower both feed hopper end flips (arrow down, rear controller).
15. Ensure that the tank valves are all open (T1-T5) (see section 11.2.1 "Valve chart for Dens-X" ).
16. Fold down the stairs (see section 4.2.7 "PTO Speed" ).
17. Start the tractors PTO. IMPORTANT: Check the rotational direction of the PTO (see section 4.2.6
"Power take off" ).
18. Run the PTO at about 300 RPM.
19. Maintain this speed until the oil has reached the appropriate operating temperature (see section
4.2.10 "Oil temperature" ).
20. Increase the speed to 850 RPM.
21. Lower the wrapping table to its horizontal position.
22. Fold down the bale bridge.
4 OPERATION 38