ORKEL Dens-X Compactor, Руководство пользователя

Страница: 93 / 142

Oils can be hot.
Some pressure can remain in the hydraulic system/hoses/pipes, even though the machine is
shut down.
IMPORTANT: Always change filters when changing the hydraulic oil!
7.14.1 Changing oil and filter
Hydraulic oil
1. Heat the oil up to about 30°C.
2. Slightly tilt the compactor towards the drain plug. The plug is placed on the underside of the tank.
3. Shut down the machine and disconnect the PTO.
4. Place an empty container beneath the drain hole.
5. Remove the drain plug.
6. Drain until empty. Approximately 130 L of oil.
7. Clean up the oil spill.
8. Reinsert the drain plug (replace sealing if necessary).
9. Change the oil filter according to the “Filter”-procedure below.
10. Drain the oil and remove the oil filter on the collector according to the “Collector and cooler”-pro-
cedure.
11. Refill. A sticker on the oil tank indicates the applied oil type.
12. Check the oil level.
13. Run the compactor for a while, top up if necessary.
14. Dispose with the old oil according to environmental regulations.
Collector and cooler
1. Place an empty container beneath the drain hole.
2. Remove the drain plug.
3. Drain until empty. Approximately 10 L of oil.
4. Clean up the oil spill.
5. Reinsert the drain plug (replace sealing if necessary).
6. Change the oil filter according to the “Filter”-procedure.
Changing filter
1. Locate the desired filter to be replaced.
2. Place an empty container beneath the filter insert.
3. Remove the filter.
7 MAINTENANCE AND MECHANICAL ADJUSTMENTS 93