CSD2109-P, CSD2112-P, CSD2120-P
18
Installing the driver
When installing the driver in an enclosure, be sure
to follow the diagram illustrated below.
Provide a minimum clearance of 25 mm in the
horizontal direction or 50 mm in the vertical
direction between the driver and enclosure or
other equipment within the enclosure.
When installing two or more drivers side by side,
provide a minimum clearance of 20 mm between
drivers.
Mount the printed circuit board or heat sink to the
mounting plate.
(Screws and spacers are not supplied.)
Hexagonal nut
M3 screw
C
N2
MO
TO
R
C
N1
SIGN
AL
Mounting plate
Spacer
(insulation material)
Mounting the printed circuit board
Mount the printed circuit board to the mounting
plate using M3 screws.
Insert a spacer (5 mm or thicker ) between the
printed circuit board and the mounting plate.
Mounting the heat sink
Mount the heat sink to the mounting plate using
M3 screws.
●
Installation in the horizontal direction
●
Installation in the vertical direction
Hexagonal nut
M3 screw
Mounting plate
1 2
3 4
OF
F
VEXTA
C.C.+
C
.C.-
ACD
F/H
1P/2P
24/36V
RUN
VR
STOP
VR
P0W
Install the driver so
that the connector
is positioned on the
bottom side.
Spacer
(insulation material)
M3 screw
M3
Effective depth 5 mm
1 2
3 4
1 2 3 4
OFF
OFF
Mounting plate
Spring washer