Oracle Sun Fire X4240, Руководство по обслуживанию

Страница: 71 / 190

Chapter 4 Servicing Motherboard Components 4-9
4. Push the DDR2 DIMM into the connector until the ejector tabs lock the DDR2
DIMM in place.
If the DDR2 DIMM does not easily seat into the connector, verify that the
orientation of the DDR2 DIMM is as shown in
FIGURE 4-5
. If the orientation is
reversed, damage to the DDR2 DIMM might occur.
5. Repeat Step 2 through Step 4 until all replacement DDR2 DIMMs are installed.
6. Replace the air duct to the down position.
7. Install the top cover.
See Section 6.1, “Installing the Top Cover” on page 6-2 .
8. Slide the server into the rack.
See Section 6.3, “Returning the Server to the Normal Rack Position” on page 6-4 .
9. Reconnect the power cord (or cords) to the power supply (or supplies).
Verify that the AC Present LED is lit.
See Section 6.4, “Powering On the Server” on page 6-5 .
10. Power on the server.
See Section 6.4, “Powering On the Server” on page 6-5 .
FIGURE 4-5
Installing DDR2 DIMMs
4.1.5 Installing Additional DDR2 DIMMs
Before you begin, see Section 4.1.2, “DDR2 DIMM Guidelines” on page 4-4 , for
information about DDR2 DIMM configuration guidelines.