Oracle netra X5-2, Руководство по обслуживанию

Страница: 120 / 274

Power Supply LEDs
Power Supply LEDs
The status of each power supply is represented by three LEDs. The LEDs are located to the left
of the fan of each power supply. See “Rear Panel LEDs” on page 33 . This table describes the
functionality of the power supply LEDs.
Icon Location Name Color State and Meaning
Top OK Green
On
– Power supply is functional without fault.
Off – Power supply is off, in standby mode or initializing.
Middle Attention
Service Required
Amber On – Normal fault detected.
Off – No faults detected.
Bottom AC or DC Green
On
– Input power present and good.
Off – Input power not present.
Related Information
■
“Locate a Faulty Power Supply” on page 120
■
“Remove a Power Supply” on page 122
■
“Front Panel LEDs” on page 31 “Rear Panel LEDs” on page 33
Locate a Faulty Power Supply
You must determine which power supply is faulty before you replace it.
1. Check to see if any System Service Required LEDs are lit or flashing.
See “Interpreting Diagnostic LEDs” on page 30 .
2. Visually inspect the power supplies to see if any of their status LEDs are lit or
flashing.
See “Power Supply LEDs” on page 120 .
If a power supply is faulty, replace it. See “Remove a Power Supply” on page 122 .
3. In Oracle ILOM, check the health of the power system.
-> show /System/Power
/System/Power
Targets:
Properties:
health = OK
120 Netra Server X5-2 Service Manual • October 2016