OPTIMUM Maschinen OPTIturn 3432420, Руководство по эксплуатации

Страница: 44 / 138

Operation
Version 1.0.5 - 2020-12-09 44 Translation of original instruction
TX4414 EN
T
X
4414
_GB
_4.
fm
4.13 Mounting workpiece holder
DANGER!
Please observe the maximum permissible rotational speed of chucks and face plates
with individually tensionable jaws.
4.13.1 Centering point in lathe spindle

Clean the taper bore of the lathe spindle holding fixture.

Clean the morse taper and the taper of the centring point.

Push the fixed MT5 center with reducing cone MT5 obtained in your delivery into the inter-
nal taper of the spindle holding fixture.
4.14 Mounting of rests
INFORMATION
Steady rests are not included and are optionally available.
4.14.1 Follow rest and steady rest
Use steady rest or follow rest to support longer parts and prevent the workpiece from flapping
around and flying away.
CAUTION!
When mounting a rest, the rest is due his function near the top slide, which results in
additional crushing and shearing points between the guide of rest and the workpiece.
Increased attention is therefore absolutely necessary when working with an rest.
4.15 General operating instructions
4.15.1 Longitudinal turning
In the straight turning operation, the tool
feeds parallel to the axis of rotation of the
workpiece. The feed can be either manual
- by turning the handwheel on the lathe
saddle or the top slide - or by activating
the automatic feed. The cross feed for the
depth of cut is achieved using the cross
slide.
Img. 4-8: Graphic: Longitudinal turning
Feed
In
fee
d