![background image](http://html.mh-extra.com/html/omron/sysmac-cpm2b/sysmac-cpm2b_operation-manual_1633427168.webp)
150
Programming Console Operations
Section 7-2
7-2-25 Unsigned Decimal Data Modification
This operation is used to change the decimal value of a word being monitored
as unsigned decimal data, within a range of 0 to 65,535. A change into hexa-
decimal data is made automatically.
Words SR 253 to SR 255 cannot be changed.
!Caution
Before changing the contents of I/O memory, be sure that the changes will not
cause equipment to operate unexpectedly or dangerously. In particular, take
care when changing the status of output bits. The PLC continues to refresh I/
O bits even if the PLC is in PROGRAM mode, so devices connected to output
points on the CPU Board or Expansion I/O Boards may operate unexpectedly.
1,2,3...
1.
Monitor (unsigned decimal) the status of the word for which the present
value is to be changed.
(Unsigned decimal monitor)
2.
Press the CHG Key to begin decimal data modification.
3.
Input the new PV and press the WRITE Key to change the PV. The opera-
tion will end and the decimal-without-sign monitoring display will return
when the WRITE Key is pressed.
The PV can be set within a range of 0 to 65,535.
If an erroneous input has been made, press the CLR Key to restore the sta-
tus prior to the input. Then enter the correct input.
The buzzer will sound if a value outside the specified range is input, allow-
ing no writing.
7-2-26 Force Set, Reset
This operation is used to force bits ON (force set) or OFF (force reset) and is
useful when debugging the program or checking output wiring. It is possible in
MONITOR or PROGRAM mode only.
!Caution
Before changing the contents of I/O memory, be sure that the changes will not
cause equipment to operate unexpectedly or dangerously. In particular, take
care when changing the status of output bits. The PLC continues to refresh I/
O bits even if the PLC is in PROGRAM mode, so devices connected to output
points on the CPU Board or Expansion I/O Boards may operate unexpectedly.
1,2,3...
1.
Monitor the status of the desired bit according to the procedure described
in 7-2-14 Bit, Digit, Word Monitor. If two or more words are being moni-
tored, the desired bit should be leftmost on the display.
RUN
MONITOR
PROGRAM
No
OK
OK
c200
65520
CHG
PRES VAL?
c200 65520
D
3
C
2
7
6
8
WRITE
c200
32768
RUN
MONITOR
PROGRAM
No
OK
OK
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Содержание SYSMAC CPM2B
Страница 4: ...iv Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com ...
Страница 6: ...vi Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com ...
Страница 216: ...198 Index Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com ...