![background image](http://html.mh-extra.com/html/omron/sysmac-cpm2b/sysmac-cpm2b_operation-manual_1633427072.webp)
54
Wiring and Connections
Section 3-5
Terminal Block Specifications
Recommended Wire and Terminals
Note
1.
When using stranded wire, be sure to avoid stray wire strands that might
short-circuit an adjacent terminal.
2.
Do not solder the ends of stranded wires. Solder can break and cause wir-
ing problems. Also, the solder can cause corrosion on the contact surface.
3.
Be sure to use the correct pin allocation when assembling and wiring con-
nectors or terminal blocks.
Removing and Wiring a
Terminal Block
Use the following procedure when wiring a terminal block.
1,2,3...
1.
Use a flatblade screwdriver to loosen the screws at the left and right sides
of the terminal block.
2.
Pull the terminal block out of the Board.
Item
Specification
Screw size
M3
Recommended tightening
torque
0.5 to 0.6 N•m
Recommended screwdriver: OMRON XW4E-00C
Item
Specification
Solid wire
0.2 to 2.5 mm
2
(AWG 24 to AWG12) (Strip 7 mm.)
Stranded wire (See notes.)
0.2 to 2.5 mm
2
(AWG 24 to AWG12) (Strip 7 mm.)
Two-conductor
wires
Solid
2
×
(0.2 to 1.0 mm
2
) (AWG 24 to AWG 20)
Stranded
2
×
(0.2 to 1.5 mm
2
) (AWG 24 to AWG 16)
Stranded with
pin terminal
2
×
(0.25 to 1.0 mm
2
) (AWG 24 to AWG 20)
without an insulating sleeve
Pin terminals
0.2 to 2.5 mm
2
diameter, 7-mm long pin terminal
Bridge (shorts terminals)
Terminal pitch 5.08 mm
Recommended Bridges:
OMRON XW4Z-02C (2 pole)
OMRON XW4Z-03C (3 pole)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Содержание SYSMAC CPM2B
Страница 4: ...iv Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com ...
Страница 6: ...vi Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com ...
Страница 216: ...198 Index Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com ...