![background image](http://html.mh-extra.com/html/omron/sysmac-cpm2b/sysmac-cpm2b_operation-manual_1633427178.webp)
160
Programming Example
Section 7-3
7-3-5
Test Run in MONITOR Mode
Switch the CPM2B in MONITOR mode and check the operation of the pro-
gram.
1,2,3...
1.
Set the Programming Console’s mode switch to MONITOR mode.
2.
Press the CLR Key to bring up the initial display.
3.
Force-set the start input bit (IR 00000) from the Programming Console to
start the program.
The cursor in the lower left corner of the display indicates that the force set
is in progress. The bit will remain ON as long as the Set Key is held down.
4.
The output indicator for output IR 01000 will flash ten times if the program
is operating correctly. The indicator should go OFF after ten one-second
flashes.
There is a mistake in the program if the output indicator doesn’t flash. In
this case, check the program and force set/reset bits to check operation.
RUN
MONITOR
PROGRAM
<MONITOR> BZ
CLR
00000
LD
00000
LD 00000
MONTR
00000
^ OFF
SET
00000
~
ON
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Содержание SYSMAC CPM2B
Страница 4: ...iv Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com ...
Страница 6: ...vi Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com ...
Страница 216: ...198 Index Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com ...