Omron CS1W-CLK12-V1, Руководство по эксплуатации

Страница: 54 / 312

37
Message Service Procedure Section 2-2
5. Make duplex settings for Communications Units. Create I/O tables.
Note When I/O tables for configurations with Communications Units used in duplex
operation are created, the Unit with the lower slot number will be designated
as the active Unit and the Unit with the higher slot number will be designated
as the standby Unit. To reverse this designation, edit the I/O tables offline and
transfer them to the PLC.
6. Set the software switch.
Note a) This setting is made by means of a Programming Device (includ-
ing the Programming Console) for the PLC. In token-ring mode,
confirm that the relevant setting location in the DM parameters
area is 00.
b) When Optical Bus (CLK11) and Optical Ring (CLK12 or CLK12-
V1) Controller Link Units are used in combination, the software
switch at the Optical Ring Controller Link Units for selecting either
polling node or normal node must be set for normal node.
7. Register routing tables if using inter-network connections.
Contents Remarks Page
Make duplex settings for Communi-
cations Units (in PLC Setup). Required only for duplex nodes. 173
Create the I/O tables. (See note.) --- 173
Contents Remarks Page
Transmission path format setting
(See note a.) 68, 72
Contents Remarks Page
• Set the local network table --- 156
• Set the relay network table ---
Lot No.: @ @ 4 6 Manufactured in April 1996
Indicates the last digit of the manufacturing
year. In this example, the year is 1996.
Indicates the month of manufacture. October,
November, and December are indicated by x, y,
and z respectively. In this example, the month is
April.
Note
Routing tables are required if any of the CVM1 and CV-series CPU Units
in the Network has been manufactured on or before April 1996.