Omron CS1W-CLK12-V1, Руководство по эксплуатации

Страница: 259 / 312

242
Locating and Correcting Cable Disconnections Section 10-4
• Sets the control data.
• Sets the FINS command code.
06 06 Hex: NETWORK DISCONNECT DATA CLEAR
• Sends the 06 06 FINS command to all Communications Units (except the
local node) in the local network.
• Sets the control data.
• Sends the 06 06 FINS command to the Communications Unit at the local
node in the local network.
Note 1. In CS-series PLCs, the Port Enabled Flag for the port being used (A20200
to A20207 correspond to ports 0 to 7) will be turned OFF even if the PRO-
TOCOL MACRO (PMCR) instruction is being executed.
2. When using the sample program as written above, be sure that the bits and
words in the sample program are not already being used by the program
or other Special Units.
DM word Contents Function
D00000 00 02 Number of bytes of command data = 2 bytes
D00001 00 04 Number of bytes of response data = 4 bytes
D00002 00 00 Destination network address = 0 (the local network)
D00003 FF FE Destination node address = FF (broadcast to all nodes)
Destination unit address = FE (Communications Unit)
D00004 87 00 Response not required,
Transmission port number = 7,
Number of retries = 0 (Set to 0 for a broadcast.)
D00005 00 00 Response monitoring time = 0 s (Set to 0 for a broadcast.)
DM word Contents Function
D00000 00 02 Number of bytes of command data = 2 bytes
D00001 00 04 Number of bytes of response data = 4 bytes
D00002 00 00 Destination network address = 0 (the local network)
D00003 00 FE Destination node address = 00 (local node)
Destination unit address = FE (Communications Unit)
D00004 07 02 Response required,
Transmission port number = 7,
Number of retries = 2
D00005 00 64 Response monitoring time = 10 s