Omron 3G8F7-CRM21, Руководство пользователя

Страница: 163 / 238

143
Command Specifications
Section B-4
Remarks
•
To issue this command, the setting areas of the software table and data rate
must be set.
Command
OPEN_SYSTEMEX
Purpose Open the CompoNet Master Board, and let it be ready to be used.
Code 0x0002
Argument Function 1-WORD data,
specification Set 1 (ON) to enable or 0 (OFF) to disable.
Response code Normal end: 0x0000
At an error:
Hardware error: 0x8101 to 0x8109
Error of argument data format: Bit location of an error
Errors in argument data format refer to the format errors in the relevant setting
area.
Remarks
•
To issue this command, the following setting areas must be set:
[Mandatory]
•
Software table
•
Data rate
[Required when the relevant function is enabled or when the relevant function
needs the setting]
•
Logical error checking item
•
Registration Table
Bit Description
0 Communications stop due to communications error
function
1 I/O communications manual startup function
2 IN data zero clear due to communications error
function
3 to 7 Reserved area, Set 0 (OFF).
8 Registration Table function
9 Logical error checking item function
10 Network parameter function
11 Slave-Unit parameter function
12 to 15 Reserved area, Set 0 (OFF).
Bit Error location
0 Software table
1 Data rate
2 to 7 Reserved area, Set 0 (OFF)
8 Registration Table function
9 Logical error checking item function
10 Network parameter function
11 Slave-Unit parameter function
12 to 15 Reserved area, Set 0 (OFF)