3-14
Section
Connecting Another Company’s Slaves
90
The “Display Parameter Group” selection can be used to select a specific
group of parameters to display.
The width of the “No. Name” and “Setup Value” columns can be adjusted just
like the width of the columns in the device list display area.
You can click on “Default Setup” to return all of the Slave parameters to their
default values.
If there is a partially edited Slave parameter file, click on “Read from File”
and specify the filename to read the file.
When parameters are read from the Slave, click on “Read from Device” to
read the Slave’s parameters.
To compare the current settings to the contents of a file or the parameters in
a Slave, click on “Compare with File” or “Compare with Device.”
3. Set the parameters if necessary.
Select the parameter to be set and click on “Set Parameters.” The Set
Parameters window can also be displayed by double-clicking on the desired
parameter.
There are three kinds of Set Parameter windows, depending on the type of
parameter being set. These three kinds of windows are shown below.
•
The following window is for parameters set in bit units (16-bit data).
Change a parameter setting by clicking on the corresponding box. A check
mark (
n
) indicates that the setting is enabled.
•
The following window is for multiple-choice parameter settings.
Select one of the settings from the choices displayed in the bottom-half of
the window.