Olympia MILLENNIUM H, Руководство пользователя

Страница: 89 / 113

The Ultimate Ice Resurfacer 77
MILLENNIUM
H
• ¾ of a lap prior to completion of the resurfacing, turn off the wash water. Just prior to
finishing the resurfacing, turn off the ice making water. Bring the OLYMPIA Millennium H to
a complete stop while the rear wheels are still on the ice surface.
• Turn off the horizontal and vertical augers.
• Lift the conditioner. Do not move the ice resurfacer until the conditioner is in the fully
raised position.
• Proceed carefully to the snow dumping area. Prior to dumping check to ensure there is
sufficient overhead clearance. Raise the snow dump tank button until it is completely
opened.
• After dumping the snow lower the snow dump tank of after dismounting install the snow
dump safety supports.
• Engage the parking brake and turn off the ice resurfacer.
• After stepping down from the ice resurfacer, be sure to remove cover plates and wash out
the conditioner.
In order to maintain the recommended ice thickness of 1.5” (38mm), it is important that you
cut the ice at a rate equal to the water you put down. Usually between ½ and ¾ a bin of snow
will equal the amount of water put down on an 8 to 10 minute resurfacing.
Proceed with extreme caution when driving up to the snow dumping area!
The snow dumping area should meet the following safety requirements:
• Red/white cordons at the left and right of the unloading area, with pictograms.
• Yellow/black threshold on the floor that is high enough to prevent the OLYMPIA from
falling into the snow dump pit.
• Guard at the front of the snow dump to prevent people from falling in.