Olympia MILLENNIUM H, Руководство пользователя

Страница: 112 / 113

The Ultimate Ice Resurfacer
MILLENNIUM
H
□
The blade must be above the runner to prevent damage to the ice. NEVER RUN YOUR HAND FROM FRONT TO BACK ON
THE RUNNER!!!
□
Inspect the chain for proper deflection,( 1/4”-1/2”).
□
Rotate the auger until you see the master link and make sure the retaining clip is present and secure.
□
Inspect the quick couplers for leaks and proper connection Inspect the right hand side auger bearing for proper
operation.
□
Taking hold of the centre of the auger shaft check for movement north, south, east and west. The bearing should have
no play.
□
Inspect the squeegee for proper installation and damage. A damaged squeegee or improper instalment will effects the
wash waters ability to work and the life of the impeller.
□
Flip the flood towel over and inspect for dirt, debris and wear. The towel is the last thing to touch the ice, it must be
clean and in good report.
□
Inspect both flood water and wash water valve handles for ease of operation and close both valves.
□
Inspect the hand wheel for free movement, turning the blade both up and down 2 turns returning it to the original
location.
□
Inspect the right hand side auger bearing for proper operation.
□
Take hold of the centre of the auger shaft and move it to check for movement north, south, east and west. The bearing
should have no play.
□
Run your hand on the bottom of the left hand side runner of the conditioner from BACK TO FRONT, check for burrs on
the runner and note the blade position. If there are burrs present use a flat file to remove them. The blade must be
above the runner to prevent damage to the ice. NEVER RUN YOUR HAND FROM FRONT TO BACK ON THE RUNNER!!!
□
Inspect the conditioner bumper wheel making sure it spins freely.
□
Replace all conditioner cover plates and retaining pins
□
Open the compartment under the seat, flip the switch to hand pump mode and operate the system. You can lower the
conditioner slightly for this procedure. When pumping the conditioner should fully rise and then the snow bin should
start to rise. Flip the hand pump switch back to drive.
□
Removing the key from your pocket place it in the ignition
□
Using the 3 points of contact, safely mount the OLYMPIA. Never use the arm rest as a grab handle!
□
Start the OLYMPIA and make sure the OIL PRESSURE gauge is operating and you have oil pressure. If you do not, shut off
the OLYMPIA immediately.
□
Using the RPM controller, bring the OLYMPIA up to 1500RPM.
□
Inspect the tachometer for proper function.