Oliver 10010, Руководство пользователя

Страница: 24 / 44

FIG. 37
Press and Hold the Arbor
Lock While Turning the
Wrench to Loosen the Flange
FIG. 38
FIG. 39
SPHC Steel
Sanding Disc
PSA
Sanding Paper
FIG. 40
Handle
Storage
Foot
STEP 4: Press and hold the arbor lock
and use the arbor wrench (included)
turning counterclockwise to loosen the
blade flange as shown in
FIG. 37
, and
then remove the arbor nut, flange, and
blade.
STEP 5: Place a new blade, outer
flange and arbor nut on the arbor as
shown in
FIG. 38 . Ensure the blade
teeth point down to the front side of the
table saw.
STEP 6:
Reinstall blade guard assembly
and table insert (See C. BLADE GUARD
ASSEMBLY on page 17).
K. REPLACE SAW BLADE WITH
SANDING DISC
STEP 1:
Follow Step 1 to Step 4 from J.
REPALCE SAW BLADE on page 23 to
remove the saw blade.
STEP 2:
Remove the film on the
sanding paper and adhere on the
sanding plate. See
FIG. 39 .
NOTE:
When the table saw is in
sanding mode, the blade guard
assemble and riving knife are not
installed.
L. USE THE ROLLING STAND
To move the machine using the rolling
stand, press the leg release button on
each leg (See page 19) to fold the legs.
Place the wheel on the ground and tilt
the saw until rest it on the storage foot.
To move the saw, tilt it forward and pull
using the handle as shown in
FIG. 40.
J. REPLACE SAW BLADE
(CONTINUED)
Oliver 10010 10" Job Site Saw Owner's Manual 24