Oliver 10010, Руководство пользователя

Страница: 31 / 44

STEP 13:
Reinstall the blade guard
assembly.
STEP 14:
Reinstall the table insert.
B. FENCE AND SAW BLADE
ALIGNMENT
To check the alignment,
STEP 1: Remove the blade guard (See
page 17 C. BLADE GUARD
ASSEMBLY).
STEP 2: Raise saw blade all the way up
to its maximum height.
STEP 3:
Set the bevel to 0
°
angle.
STEP 4:
Slide the fence towards the
saw blade and contact the saw blade
as shown in
FIG. 47 .
STEP 5: Check to see if they are
parallel to each other. If they are not,
continue STEP 6.
STEP 6: Adjust the screws under the
rail/fence as shown in FIG. 48 to align
the fence to the saw blade.
STEP 7:
Once adjustment is down,
reinstall the blade guard.
DISCONNECT THE MACHINE FROM
POWER BEFORE FOLLOWING THE
STEPS!
FENCE MUST ALIGNE TO SAW BLADE
TO PREVENT RISK OF KICKBACK
DURING OPERATION.
A. RIVING KNIFE AND SAW
BLADE ALIGNMENT
(CONTINUED)
FIG. 48
Machine shows upside
down for clarity.
Fence
Saw Blade
FIG. 47
Oliver 10010 10" Job Site Saw Owner's Manual 31