5
4
Supplied equipment
1.
CO2-O2-UNIT-BL [0-10; 0-1]
, main box.
2.
TUBE-CB (x2)
. Silicon tube 20cm long 7mm OD with a PTFE filter in the middle. One to be installed on the
rear of the Unit and one as spare replacement.
3.
TUBE-C (x1).
Polyurethane 130cm long blue rigid tube 6mm OD with connected a 4mm ID Silicon
transparent tube 150 cm long plus PTFE filter in the middle. Use TUBE C to connect the CO2/O2 Controller
to your device or to the humidifier, if it is present.
Note
►
If you purchased CO2-O2-UNIT-BL [0-10; 0-1] with H201-T-UNIT or H101-T-UNIT, you receive the
TUBE-B
, Polyurethane 120 cm long blue tube 6mm OD connected to a Silicon 40 cm long transparent tube
4mm ID plus PTFE filter in the middle, connected to a Polyurethane 120 cm long blue tube 6mm OD. Use
TUBE-B to connect the CO2-O2-UNIT-BL [0-10; 0-1] to the cage incubator.
4.
TUBE-A (x3).
Rigid tubes, Polyurethane 3m long 6mm OD each. Use TUBE-A to connect N2, Air and CO2 supply
to the corresponding input ports (N2, Air and CO2) on the rear panel of the CO2-O2-UNIT-BL [0-10; 0-1].
5.
Pressure Gauge for CO2/N2 + reg assembly stirrup (x2).
Install pressure gauge between the pure
CO2 /N2 supply pressure regulator and the corresponding CO2/N2 input port on the rear panel of CO2-O2-
UNIT-BL [0-10; 0-1].
6.
24V-DC Power Adapter (x1)
.
7.
Oxygen Analyzer Tube (x2).
PTFE tube 135 mm long 4mm OD. Use Oxygen Analyzer Tube to connet the
Oxygen Analyzer to the main box.
1
4
5
3
2
To
N
2
s
u
p
p
ly
To CO2 supply
6
To Air supply
To N2 supply
5
7
Figure 1. CO2-O2-UNIT-BL [0-10; 0-1]
–
components.
