Oki C710, Руководство по обслуживанию

Страница: 171 / 223

43856301TH Rev.3
170 /
Oki Data CONFIDENTIAL
7. Troubleshooting and repair procedure
(8-4) Two-sided printing jam occurs during transporting paper inside the Duplex unit.
Check item Check work
Action to be taken
at NG
(8-4-1) Sensor lever operation check
Dup-R, Dup-F
sensor lever
Remove the Duplex unit and check movement of
the sensor lever.
Replace the
sensor lever.
(8-4-2) Sensor check
Check the detection
condition of the
sensor signal
Confirm that the sensor signals are normally
detected by using the SWITCH SCAN function
of the self-diagnostic mode.
For all sensors except the Dup-IN sensor, check
the detection condition of the respective sensor
in the two status: One is the status in which
paper remains inside the Duplex unit. The other
is the status in which paper is removed from the
Duplex unit.
Replace the
Duplex board
(V7Y PCB),
or replace the
defective sensor
or connection
cable.
(8-5) Paper is not supplied from the Duplex unit to the regist roller.
Check item Check work
Action to be taken
at NG
(8-5-1) Clutch operation check
Duplex clutch Confirm that the Duplex clutch works normally
by using the Motor & Clutch Test of the self-
diagnostic mode.Confirm it by listening to the
sound.
Replace the
V7Y board or
clutch.
7.5.2. (9) Paper size error (error code 400)
(9-1) Jam occurs when paper end is located near the IN1 sensor.
Check item Check work
Action to be taken
at NG
(9-1-1) Check paper feed condition
Multifeed of papers Open the front cover and check if multifeed of
papers occurs or not.
If the multifeed
occurs again
after the
jammed paper
is removed,
replace the flap
of the tray in
use.
Paper size Does the paper size specified for print match the
paper size of paper stuck in the tray.
Change the
specified paper
size or size of
paper inside the
tray.
Paper entrance
sensor 1
Check if shape and movement of the sensor
levers have any abnormality or not.
Replace the
sensor lever
with the good
sensor lever.