OETIKER EPC 01, Инструкция по эксплуатации, Страница: 91 / 98

91 www.oetiker.com
OETIKER EPC 01
aPPenDIX
Issue 11.22 08905306
13 3 5 Mapping list
Input
Offset Length
[Byte]
Bit
Offset Type Data Description
0 1 0 bool functions Menu navigate to the functions selection menu.
1 bool aPn Menu navigate to current aPn menu. a closure process
can only be started from here.
2 bool sequence Menu navigate to sequence Menu. from this menu a
closure can be started and if this is oK, then the
next aPn is loaded automatically.
3 bool Pincer test menu navigate to Pincer test menu. a pincer test can
only be started from here.
4 bool start starts a closure or in the pincer test/stepbystep
the corresponding pincer test step. Value must be
reset to effect a restart. The enable function must
be active.
5 bool Canceled abort a started closing function.
6 bool acknowledge error acknowledge error.
7 bool Confirm the force test Confirm the force test and then move to the next
test.
1 1 0 bool enable safety control bit to ensure that a closure was not
started accidentally.
1 bool apply aPn To be activated when the aPn number is to be
input and applied.
2 bool apply sequence no. To be activated when the sequence number is to
be input and applied.
3 bool apply nominal force To be activated when the nominal force is to be
input and applied.
4 bool n/a
5 bool n/a
6 bool n/a
7 bool n/a
2 2 Int applicable aPn selects the current aPn. aPn number must be
> 0 and the aPn settings must correspond the
locked pincer. active only in the «Ready» status
and in the aPn menu.
4 2 Int applicable sequence selects the current sequence. sequence num-
ber must be > 0 and the aPn settings must
correspond the locked pincer. only active in the
«Ready» status and in the sequence menu.
6 2 Int Measured nominal
force applies the measured nominal force. The nominal
force must be > 0. only active during the pincer
test and when the «nominal force input allowed»
flag is active. Can only be set 1x / force test
closure.
8 110 --- n/a