Oerlikon CITOTIG 315, Руководство оператора

Страница: 14 / 429

English 10 English
Polarity:
This icon is designated to set the polarity of the process
in use: DC+, AC stick, DC- & AC TIG operations.
NOTE:
Pressing the button assigned to process
POLARITY will toggle the illumination of the icon
between DC & AC polarity.
Process:
The function of this icon is to allow the user to set the
determined process.
1. High-Frequency TIG
2. Lift-Start TIG
3. Stick – Soft Mode (7018 style electrodes)
4. Stick- Crisp Mode (6010 Style electrodes)
NOTE: Arc control parameters, Hot start and arc force
parameters, are different in two stick modes. In menu
SMAW is possible to change hot start and arc force
diagram.
NOTE: Pressing the button assigned to PROCESS
selection will toggle the illumination of the icon from left-
to-right following the progression of the numbers.
Output:
This section is designated to allow the operator to set
the desired output control method
1. 2 STEP
2. 4 STEP
3. ON: no trigger required to start.
Pressing the button assigned to OUTPUT selection will
toggle the illumination of the icon from left-to-right
AC Wave Shape:
These icons allow the operator to customize the arc-
performance for TIG welding in AC polarity only.
AUTO and Expert Mode:
By default the AUTO icon is lit. This means that AC
waveshape parameters are automatically managed
depending on the welding current. The only available
parameter is AC-Frequency.
AC-Frequency: This function controls the frequency of
the AC Wave shape in cycles per second
To enable Expert mode:

Push the AC WAVESHAPE button twice: The AUTO
icon will start to blink and the display will show the
message AUTO ON.

Turn the encoder to select AUTO OFF

Confirm the selection by pushing the AC
WAVESHAPE button again. The AUTO icon will turn
OFF and all the AC WAVESHAPE parameters will
become available.
To revert to AUTO mode perform again the steps above
pushing several times until AUTO icon will start blinking,
then select AUTO ON with the encoder.
In Expert mode the following parameters are available:
1. AC-Frequency: This function controls the frequency
of the AC Wave shape in cycles per second.
2. AC-Balance: AC balance controls the amount of
time, as a percentage, that the polarity is electrode
negative.
3. Electrode Negative/Positive offset: This function
controls the amperage setting for the negative and
positive side of the wave when TIG welding in AC
polarity.
The voltage display screen shows an abbreviated
description of the icon selected. The amperage display
screen shows the value to be adjusted.