ODA EX 10000, Брошюра и инструкция по эксплуатации

Страница: 26 / 113

EX Series Operating Manual
3-1. Constant Voltage Operating(CV)
To set up the power supply for constant voltage (CV) operation, proceed as follows.
(This operating is the examples that the function of "Last State Mode" is disable.)
▌Turn on the power supply
After turned on, check the power supply displays"
**OUTPUT OFF**
" Mode. , p pp y p y
▌Connect the DUT to output terminals.
▌In other to set the limit value, press the LMT Key.
▌Press the left key and move the under bar cursor to voltage value. In other to
increase or decrease the voltage value, turn the encoder switch CW or CCW.
Under the protection(OVP/UVL/OVL) setting state voltage cannot be over Under the protection(OVP/UVL/OVL) setting state, voltage cannot be over
protection level. If the voltage value is over the protection setting value,
instrument "displays "PROTECTION LIMIT" message and voltage will set to
protection level value.
▌If you set the current value higher than DUT consumes real value, you can
prevent to damage the DUT. Refer to below procedure of current setting.
▌In other to set the current value, use the right cursor key and encoder knob.
Under the protection(OVP/UVL/OVL) setting state, current cannot be over
protection level. If the voltage value is over the protection setting value,
instrument "displays "PROTECTION LIMIT" message and current will set to
protection level value.
▌If the all setting is finished, enable the output.(Press the output ON/OFF key)
d h l h db k di l f li i di l and then power supply changes to readback display from limit display.
▌CV lamp is on, CC lamp is off.
If lamp is reversed, check the current setting value is low.
If the current value is low, increase the current value limit.
≫ Related remote interface command
APPLy{<voltage>,<current>} APPLy{<voltage>,<current>}
VOLT{<voltage>|UP|DOWN}
CURR{<current>|UP|DOWN}
OUTP{OFF|ON}
Apply 1 OUTP OFF disable the output Apply 2 OUTP OFF disable the output
VOLT 10 set the voltage to 10V APPLY 10,5 set 0V /5A
CURR 5 set the current to 5A OUTP ON enable the output
OUTP ON enable the output OUTP ON enable the output
1. Left cursor key is for voltage under bar left moving, right cursor key is for current under
bar right moving.
2. About readback Display? Display state that is the voltage and current,s output.
Note
- 26 -