Ochsner AIR FALCON 212 C11A T200, Руководство по проектированию и установке

Страница: 26 / 68

26 www.ochsner.com | 00_200_202_08_01_002-EN
Machine-specific engineering and preparation
A B
AIR FALCON 212 200 mm Ø 125 mm
Refrigerant line routing from below
Note
Refrigerant line routing from below only works in
the case of outdoor units with a wall bracket.
»
For outdoor units with a floor foundation, use
the break-out openings on the outdoor unit.
1 Outdoor unit
2 Refrigerant lines
3 Pipe liner for underground connecting lines
4 Surplus length of refrigerant lines for connection
A
AIR FALCON 212 Ø 125 mm
8.2.3 Material requirements
The pipe diameter data for refrigerant lines shown below
applies, provided the following is observed:
► Maximum 8x90° bending radii
► Use suitable fittings for bends
► Bending radii of ≥ 1 m are considered as straight runs
Hot gas line
Copper pipes
Requirement Diameter
AIR FALCON
212
R220 (soft, in rings) to EN
12735-1
16x1
Fittings
Requirement
AIR FALCON
212
Max. permissible operating pressure 46 bar
Max. permissible temperature 130°C
Used with refrigerant R32
Note
The insulation used for the hot gas line must com-
ply with the requirements for high temperature
applications.
Liquid line
Copper pipes
Requirement Diameter
AIR FALCON
212
R220 (soft, in rings) to EN
12735-1
8x1
Fittings
Requirement
AIR FALCON
212
Max. permissible operating pressure 46 bar
Max. permissible temperature 70°C
Used with refrigerant R32