Oce WP36/50, Руководство по эксплуатации

Страница: 74 / 115

Chapter 3 Using the Operator Panel
3-53
Press the
ENTER
key. A blinking cursor (
_
) appears.
Press the or key to increase or decrease the val-
ue of the figure where the cursor is blinking and set
the desired time. The time must be set between 000
and 495 seconds, in 5-second increments. If set to
000, printing will be continued immediately without
allowing any time interval. You can use the and
keys to move the cursor right and left.
Display the desired time and press the
ENTER
key.
Press the
MENU
key. The message display returns to
Ready
.
Finishing
These settings are possible only when the optional finisher is
installed on the printer.
Duplex Printing Error Detection Setting
This setting controls whether or not the message
Duplex
disabled Press
GO
appears when label or some other type
of paper that is not supported for duplex printing is specified
as the paper type when duplex printing is being performed.
Press the
MENU
key.
Press the or key repeatedly until
Others >
ap-
pears.
Press the key.
Press the or key repeatedly until
>Finishing
Error >
appears.
Press the key.
Press the or key repeatedly until
>>Duplex
appears.
Press the
ENTER
key. A blinking question mark (
?
)
appears.
Press the or key to change
Off
to
On
.
Press the
ENTER
key.
To exit the menu selection, press the
MENU
key.
Staple Error Detection Setting
This setting controls whether or not message
Add staples
appears when the finisher units runs out of staples during
output of a stabled job.
Press the
MENU
key.
Press the or key repeatedly until
Others >
ap-
pears.
Press the key.
Press the or key repeatedly until
>
Finishing Error >
appears.
Press the key.
>>Auto Continue
Timer 030Sec.
On
• Press the
GO
key to perform simple printing.
• Press the
CANCEL key
to cancel the print job.
Off
Disable duplex printing. (reverts to simplex
printing)
Others >
>Finishing >
Error
6
7
8
9
1
2
3
4
5
>>Duplex
OFF
>>Duplex
? Off
On
Message is displayed and printing pauses.
Printing resumes automatically when staples
are replenished.
Off
Message is displayed, but printing continues
without stapling.
Others >
>Finishing >
Error
6
7
8
9
10
1
2
3
4
5