Oce 9800, Руководство пользователя

Страница: 29 / 148

Using the Océ 9800 Printer 29
Printing on cut sheet media
If you want to print a job on paper of a type and/or size that is not available on
one of the paper rolls, it may be easier to manually feed in sheets of paper
instead of changing one of the paper rolls. The sheet feed is a special slot
located just above the printer’s paper roll drawers. You can insert pre-cut copy
media into this slot, one sheet at a time.
Note:
Use only the media types and sizes specified in ‘Copy material
specifications’ on page 121.
▼
Printing on pre-cut sheets
1
Select the ‘Manual feed’ setting on your printer driver before sending the job
to the printer.
Note:
More information about the Océ 9800 Job Director, the Océ 9800
Repro Station and other printer drivers can be found in separate user
manuals.
2
Wait until a message similar to the following example appears in the printer
display:
‘Sheet feed, feed A1 copy media’.
3
Take your sheet of copy media to the side of the printer which houses the sheet
feed.
4
Use both hands to align the copy material in the sheet feed in accordance with
the format indication and the sticker on the manual feed table.
5
Move the copy material forward into the nip of the roller until it causes an
ample bulge over the full width of the page.
6
Hold the copy material with both hands until the printer pulls in the first part
of the sheet.
The bulge will be reduced or it will disappear. A few seconds later, the
complete sheet will be pulled into the printer.