Operating & Maintaining the Objet30 3-D Printer
7–4
DOC-24000 Rev. C
Loading Model and Support Cartridges
Objet30
printers
use
two
cartridges
of
model
material
and
two
cartridges
of
support
material,
each
weighing
one
kilogram
when
full.
A
graphical
representation
of
the
cartridges
and
their
current
weight
appears
in
the
(see
3).
Note:
The printer-control interface displays the type and weight of the
material cartridges loaded only if the printing-materials drawer is
closed.
Important:
If
you
need
to
replace
the
model
material
currently
installed
with
another
type,
see
Otherwise,
make
sure
to
replace
the
model
cartridge
with
one
containing
the
same
type
of
material.
To load model and support cartridges:
1. On
the
front
of
the
Objet30
printer
(see
1),
push
the
printing
‐
materials
drawer
to
release
it
and
pull
it
open.
2. If
you
are
replacing
a
cartridge,
remove
the
old
one
by
pulling
it
straight
up.
3. Load
model
and
support
cartridges
into
their
respective
compartments
(see
Figure 7-4: Printing-materials drawer
You
should
feel
some
resistance,
as
a
needle
pierces
the
cartridge.
The printer uses RFID technology to automatically identify the material
cartridges. For this purpose, an RFID module is part of the printer hardware.
Tampering with this module will render the printer inoperable and may void
Objet warranties and service contracts.
Содержание Alaris30
