Oberheim MC 3000, Руководство по эксплуатации

Страница: 61 / 76

MC 3000
Operating Manual
131
N.B. For the aftertouch test, the dynamic response curve is set in the previous page
(edit dynamic curves).
The START and END fields can be used to set the points on the horizontal axis where the
curve to be drawn is to start and finish. The corresponding values on the vertical axis are
in the respective VALUE fields (below them).
The entire method for construction and/or modification of the curve is identical to that
described in point 6.6.2 for construction of the dynamic curves.
Naturally, the only difference is in the axes, which in this case represent the physical
pressure applied to the key (x axis) and the respective MIDI Aftertouch value (y axis)
To modify the values between the START and END points, locate in the field M which
represents the angle coefficient and vary the value until you obtain the form of curve (if the
START and END points coincide with the beginning and end of the curve) or portion of the
curve required.
The value in the Q field can be increased to move the curve or portion of the same
upwards parallel to the x axis; if the value of this parameter is reduced, the curve will be
moved down.
Example curve C1
Curve C1 after application of a positive value to parameter "q" : q = +
Direction of shift