Oberheim MC 3000, Руководство по эксплуатации

Страница: 31 / 76

MC 3000
Operating Manual
101
The word DEFAULT appears below CC NR. In line with this, the value of that slider for
the control assigned to it when the patch is recalled (i.e. the default value) appears
below each slider. After locating on these values with the cursor keys, the user can turn
the encoder or use the INC and DEC keys to modify them.
Important note: when setting the default value of the volume, reverb and chorus, make
sure that this operation has not already been carried out in the MESSAGES 1 page; To
avoid the presence of contradictory data, it is advisable to set OFF status for all data
which could be set in other pages.
4.6.3 PEDALS
The PEDALS page can only be accessed from the SLIDERS page of the CONTROLLERS
section, by pressing the F6 function key.
MC 3000 is able to support on its inputs both switch (i.e. sustain) and expression pedals
(i.e. volume). Evidently a switch pedal will send only two MIDI messagges (0 when pedal
is released and 127 when pedal is pressed) while an expression pedal will be able to send
the entire data range (from 0 to 127)
Please note that the instrument supports the following types of pedals:
•
Switch Pedals: Pedals with a NORMALLY CLOSED contact
•
Expression Pedals: Pedals equipped with a stereo jack connector. The input
impedence must be included from 10 to 22 Kohm.
N.B The use of unsuitable padals may causes damage to the machine's electronic
components.
Here again, the top of the display contains the name of the current page, the name of the
current patch and the lights indicating the activation status of its zones.
The ZONE field appears below this; after locating here with the cursor keys, the user can
turn the encoder or use the INC and DEC keys to select the zone where a specific type of
control is to be assigned.
The 8 pedals are shown in the centre of the display.
Numerical values which identify the type of control assigned to the pedal corresponding, or
OFF indicating that the pedal in question is not active in the current zone, appear below
each pedal in line with CC NR. After locating on these values with the cursor keys, the
user can turn the encoder or use the INC and DEC keys to select the type of control to be
assigned to the corresponding pedal. The name of the control selected will appear
automatically in the top of the screen, beside CC NAME, as a display message only.
The word DEFAULT appears below CC NR.
Zone
CC assigned
to pedals Default
Value