Oberheim MC 3000, Руководство по эксплуатации

Страница: 55 / 76

MC 3000
Operating Manual
125
As in the similar WRITE PROGRAM CHANGES page already examined, in this page the
user is prompted to assign a location to the SYS-EX table just acquired or constructed,
and to press WRITE again to save the exclusive code string or ESC to abort the saving
procedure. To give a name to this code, the user presses the function key F6 (NAME)
and the SYS-EX NAME ASSIGN subpage will appear:
Here the user assigns the name to the exclusive code using the procedure already
described for the similar TABLE NAME ASSIGN subpage.
Once the name has been typed, it is confirmed by pressing F6 (DONE).
At this point the WRITE SYS-EX subpage will return to the display, and the user can
decide whether to abort the procedure or save all the modifications by pressing ESC or
WRITE respectively.
6.6 EDIT CURVES
6.6.1 Introduction
The EDIT CURVES section is accessed from the UTILITY MASTER page by pressing
function key F5.
This section allows the user to create up to 48 user key velocity response curves, 48 user
aftertouch response curves.
6.6.2 DYNAMIC CURVES
This is the first video page, which appears automatically when the section is accessed.
The top of the display contains information about the operating mode, the page and the
current section. The bottom of the screen carries the usual icon rectangles indicating the
pages in the section; the first, marked DYN, is in reverse since it represents the current