NXP Semiconductors MPC5602S, Справочное руководство

Страница: 313 / 1344

Deserial Serial Peripheral Interface (DSPI)
MPC5606S Microcontroller Reference Manual, Rev. 7
Freescale Semiconductor 311
the DSPI initiates and controls the transfer according to the fields in the SPI command field of the TX FIFO
entry. In Slave mode the DSPI only responds to transfers initiated by a bus master external to the DSPI and
the SPI command field of the TX FIFO entry is ignored.
11.8.3.1 SPI Master mode
In SPI Master mode the DSPI initiates the serial transfers by controlling the serial communications clock
(SCK_
x ) and the peripheral chip select (CS x ) signals. The SPI command field in the executing TX FIFO
entry determines which CTARs are used to set the transfer attributes and which CS x signal to assert. The
command field also contains various bits that help with queue management and transfer protocol. The data
field in the executing TX FIFO entry is loaded into the shift register and shifted out on the serial out
(SOUT
_x ) pin. In SPI Master mode each SPI frame to be transmitted has a command associated with it,
allowing for transfer attribute control on a frame-by-frame basis.
Refer to Section 11.7.2.6, DSPI PUSH TX FIFO Register (DSPIx_PUSHR) , for details on the SPI
command fields.
11.8.3.2 SPI Slave mode
In SPI Slave mode the DSPI responds to transfers initiated by an SPI bus master. The DSPI does not initiate
transfers. Certain transfer attributes such as clock polarity, clock phase, and frame size must be set for
successful communication with an SPI master. The SPI Slave mode transfer attributes are set in the
DSPI
x _CTAR0 register.
11.8.3.3 FIFO disable operation
The FIFO disable mechanisms allow SPI transfers without using the TX FIFO or RX FIFO. The DSPI
operates as a double-buffered simplified SPI when the FIFOs are disabled. The TX and RX FIFOs are
disabled separately. The TX FIFO is disabled by writing a 1 to the DIS_TXF bit in the DSPI
x _MCR. The
RX FIFO is disabled by writing a 1 to the DIS_RXF bit in the DSPI x _MCR.
The FIFO disable mechanisms are transparent to the user and to host software; transmit data and
commands are written to the DSPI
x _PUSHR and received data is read from the DSPI x _POPR. When the
TX FIFO is disabled, the TFFF, TFUF, and TXCTR fields in DSPI x _SR behave as if there is a one-entry
FIFO but the contents of the DSPI x _TXFRs and TXNXTPTR are undefined. When the RX FIFO is
disabled, the RFDF, RFOF, and RXCTR fields in the DSPI x _SR behave as if there is a one-entry FIFO but
the contents of the DSPI x _RXFRs and POPNXTPTR are undefined.
Disable the TX and RX FIFOs only if the FIFO must be disabled as a requirement of the application's
operating mode. A FIFO must be disabled before it is accessed. Failure to disable a FIFO prior to a first
FIFO access is not supported, and can result in incorrect results.
11.8.3.4 transmit First In First Out (TX FIFO) buffering mechanism
The TX FIFO functions as a buffer of SPI data and SPI commands for transmission. The TX FIFO holds
five entries, each consisting of a command field and a data field. SPI commands and data are added to the
TX FIFO by writing to the DSPI push TX FIFO register (DSPI
x _PUSHR). For more information on