Nussbaum ATT Liga C 253, Инструкция по эксплуатации

Страница: 27 / 92

ENGLISH • Instructions manual
27 TC 355 - Liga C 253 TC 355 - Liga C 253
3) Depress the pedal all the way down ( 5, Fig. L ): the four clamps ( 6, Fig. L ) on the table top
will open. When the pedal is depressed again, the clamps should close.
4) Depress the pedal ( 7, Fig. L ) to tilt the post ( 8, Fig. L ) back to non-working position.
Depress the pedal again, the post will recouple in its working position.
5) Move the button ( Fig. M2 ) to its middle position ( B ): the vertical arm ( 10, Fig. L ) moves
down to facilitate placing the head against the rim edge.
Press the button (
Fig. M2 ) down ( C ): the working arms ( 10-11, Fig. L ) lock simultaneously
and the head automatically moves 2 mm away from the rim edge (see chapter on demounting).
Press the button (
Fig. M2 ) down ( A ) from inside: the working arms unlock simultaneously and
the vertical arm lifts ( 10, Fig. L ).
6) Check that a drop of oil drops into the lubricator glass cup ( 12, Fig. L ) after every two or
three movements of the footpedals ( 3 or 5, Fig. L ).
Oil feed may be regulated by means of the Lubricator adjusting screw ( see Fig. M3 ).
7) Push the control lever ( 17, Fig. L ) downwards: this should make the leverless mount hook ( see Fig. M4 ) move; by pulling the control lever
up the hook should go back to the rest position ( see Fig. M5 ).
M2
A B
C
M3
M4
M5
The illustration shows a rim fitted on the chuck, showing the positions of
the hours as if on a clock.
In the various operating stages described below, when a position (of the
valve, bead presser, tools, etc,) is mentioned, reference is ALWAYS made to
these positions.
N.B.:
The 12 o’clock position is in line with the vertical post of the tyre
changer.
10. WORKING POSITIONS
11
1
12
9
6
3
10
8
7
5
4
2