Nu-Flame The Icona 600 H.E., Инструкция по использованию, установке и обслуживанию

Страница: 11 / 50

11
l. A flat area must be left around the opening to cater for the Trim Style ordered.
The sizes required for each trim are:
Width (mm) Height (mm)
Harmony trim
670mm 425mm
Deluxe trim 770mm 525mm
Grande trim 1025mm 680mm
Concept trim 770mm 425mm
m. The Building enclosure should have provision for a gas supply as detailed in Section 11 during construction of the Enclosure.
n. If plaster board is used to face off the Building Enclosure and it is dry lined to the wall (fixed with plaster dabs) then the air gap
between the Plaster Board and the Wall must be sealed off around the cut out. Do not use a foam sealants as this will flow up the gap
sealing off the important insulating air gap above the fire, causing the chimney breast to run hot that could affect any wall coverings.
! IMPORTANT !
The Required Opening Sizes are different for a Fire with Trim or Trimless Installation.
! IMPORTANT !
Dry lined walls – ensure that any air gaps between the back of the plasterboard and wall are sealed
around the Builders Opening or Fireplace as this can affect flue pull and wall staining, see ‘
i ’.
12.4 - FIXING THE FIREBOX SUPPORT BRACKET ASSEMBLY
We Recommend the use of the Firebox Support Bracket as it is provided to cater for the weight of the Fire when fully In-
stalled with the Burner Box Assembly and Flue Hood or the Flue Canopy dependant on the type of Installation.
a.
One Support Bracket Assembly is provided with the fire for fixing at the rear of the Builders Enclosure.
The Support Bracket provides adjustment for Building Enclosure depths up to 345mm deep. For deeper Building Enclosures
spacers will be required but they must be made of a non- combustible material..
b. The top of the Support Brackets should be fixed to the rear of the Builders Opening such that they are level with the base of the
Builders Opening.
c. The fixing should be positioned as shown starting with the lower holes 25mm below the level of the bottom of the Enclosure Open-
ing and the remaining holes as shown. See diagram.
Proceed to Section 19 Fixing the Fire