Novexx ALX 924, Руководство пользователя

Страница: 71 / 91

User Manual
ALX 92x
09/2016 | 00 71 Startup and Operation
 The sensitivity of the label sensor is set too low. Materials with weak contrast between the ma-
terial and backing paper or between the reflex marking and the material require increased sensor
sensitivity.
 Increase the sensitivity.
 Punch definition, material type and/or material length are specified incorrectly in the print
job.
 Check the print job.
After confirmation with the online key, the material is automatically fed forward and the system
searches for the next punch.
5002
Material end
There is no more material in the material sensor.
 Label roll is used up.
 Insert a new label roll.
 Material guide not set correctly - the label starting marks are running past to the side of the label
sensor.
 Check/correct the material guide setting.
5003
Cover open
 The front cover of the printer is open.

Close the front cover.
Closing the front cover automatically deletes the error message.
5008
Foil end
In thermal printing:
 Ribbon end sensor is not switched off.

SYSTEM PARAMETER > Ribbon autoecon.
= „Thermal printing“.
In thermal transfer print:
 Ribbon roll is used up.
 Insert a new ribbon roll.
 The core of the ribbon roll is resting loosely on the dispenser.
 Use a ribbon roll with a suitable core diameter.
 Adjust the spring plate on the ribbon unwinding mandrel so that the ribbon core is firmly
seated.
5063
Press roll
 The lever of the backing paper feed roller (red lever) is open.
 (DPM)The lever of the backing paper feed roller (red lever) is open.
 (PEM) The lever of the label material pressure roller (green lever) is open.

Close the lever.
Closing the pressure roller automatically deletes the error message.
5071
Material end unw
 Regards the internal OD sensor. The message appears, if the material roll diameter has reached
the critical value (setable by MACHINE SETUP > Materialend err).
 Replenish the material roll.