Novexx ALX 924, Руководство пользователя

Страница: 46 / 91

Bedienungsanleitung
WACTR
09/2016 | 01 46
Print direction
[31] Alignment of the print image "Foot first" (A) or "Head first" (B).
Settings: [ „Foot first“ , „Head first“]
• "Foot first": Alignment of the print image as shown in [31A].
• "Head first": Alignment of the print image as shown in [31B]. Note the following:

Define the "true" label length (without label gaps) in parameter PRINT PARAMETERS > Materi-
allength . If the label gap is longer than 5 mm parameter SYSTEM PARAMETER > Miss. label tol. must
also be set to a value greater than zero.

The distance between the material zero line and the first printable dot is 1 mm. To maintain
this distance in head first mode, calculate the material using the following formula:
, where
b
Mat
: Material width
b
Tr
: Carrier material width
X - Printadjust
The zero point of the mask is shifted in relation to the edge of the label on the X-axis, i.e. perpen-
dicular to the material.

If the setting is changed while a print job is stopped, the printer recalculates the format with the
modified values.
Setting range: [-15.0…+15.0] mm; presetting: 0 mm
• Maximum adjust (offset) away from the edge of the label: +5.0 mm
• No offset: 0.0 mm
• Maximum offset toward the edge of the label: -5.0 mm
Y - Printadjust
The zero point of the mask is shifted in relation to the punch position on the Y-axis, i.e. in the direc-
tion of feed.

If the setting is changed while a print job is stopped, the printer recalculates the format with the
modified values.
Setting range: [-15.0…+15.0] mm; presetting: 0 mm
• Maximum offset in feed direction: +5.0 mm
• No offset: 0.0 mm
• Maximum offset opposite to feed direction: -5.0 mm
B A
b
Mat
b
Tr
2 mm – =