Novexx ALX 924, Руководство пользователя

Страница: 47 / 91

Bedienungsanleitung
WACTR
09/2016 | 01 47
SYSTEM PARAMETER menu
Label sens. type
Sensor type
Select the sensor type or the type of mark for beginning of the label (reflex marking or punch).
Settings: ["Reflex", "Punched" ]
• Reflex: Reflex sensor (detects reflex markings)
• Punched: Transmission sensor (detects reflex punches)
Ribbon autoecon.
Ribbon saving (ribbon autoeconomisation)
Ribbon saving can be used to interrupt ribbon feed through areas of the label that are not printed.
This saves ribbon, especially for long labels with very little printed surface.
Compared to the „normal“ ribbon saving function can the label throuput be considerably increased
by setting the „turbo“ ribbonsaving mode (On Turbo). This mode allows setting the feed speed in
print free areas independent from the print speed via
PRINT PARAMETERS > Feed speed .
Settings: ["Thermal/headlift" "Thermal printing", "On", "Off", „On Turbo“ ]
• "Thermal/headlift": Thermal direct printing with automatic head lifting over unprinted areas (pro-
tects the printhead)
• "Thermal printing". Thermal direct printing (ribbon end sensor shut off)
• "On": Thermal transfer printing with ribbon saving
• "Off": Thermal transfer printing without ribbon saving
• „On Turbo“: Thermal transfer printing with „turbo“ ribbon saving
Ribb. eco. limit
The ribbon economisation limit corresponds to the length of the no-print zone on the label at the
point where ribbon autoeconomisation will be activated.

Do not activate ribbon autoeconomisation for unprinted areas unless they are more than about
10 mm in length.
Setting range: [2.0…100.0] mm; presetting: 10.0 mm
Print contrast
The setting for print contrast, i.e. the degree of blackening in the printout.
Setting range: [1…110%]; presetting: 60%
CAUTION!
The
Print contrast parameter directly affects the service life of the printhead. In general,
the higher the setting of the Print contrast , the shorter the service life of the printhead.
This applies especially to settings over 100%. Therefore note the following recommen-
dation:

Always select the lowest setting that will still produce acceptable printing results.