Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008, Руководство администратора

Страница: 74 / 674

74 Novell ZENworks 7.2 Linux Management Administration Guide
n
ov
do
cx (e
n)
11
Ju
ly 20
08
7.10 Configuring the ZENworks Management
Daemon (zmd) Settings
Use the ZENworks Management Daemon Settings page to configure the Zenworks Management
Daemon (zmd) settings for your ZENworks Management Zone. These settings apply to all devices
in your ZENworks Management Zone unless they are changed on a device folder or individual
device. Any changes to the settings on this page are applied to devices upon refresh.
The zmd daemon performs software management functions on the ZENworks managed device,
including updating, installing and removing software, and performing basic queries of the device's
package management database. Typically, these management tasks are initiated through the
ZENworks Control Center or the rug utility, which means you should not need to interact directly
with zmd.
The settings that you can configure on this page can also be set using the rug utility. For information
about each setting and its corresponding value, see
rug (1) (page 571) .
To configure a zmd setting:
1 In the ZENworks Control Center, click the Configuration tab.
2
Click ZMD Settings .
3 Click Add to open the Configure Setting dialog box.
Figure 7-2
Configure Setting dialog box.
4 Fill in the fields:
Š Setting: Select a value from the Setting drop-down list.
The drop-down list contains all available settings in ZENworks Linux Management. If not
all modules are installed on a device, settings that control that module will not be used by
the zmd daemon. For example, if you do not install the Remote Control module on a
device, all settings that configure this module will be ignored.
Š Value: If the selected setting requires specific values, select the desired value from the
drop-down list. If the selected setting does not require specific values, type the value in the
Value box.
After you click
OK , if displays next to the Value box, the setting you typed is either too
small/large or you typed an invalid setting.
Š
Description: Displays the description of the selected setting.