Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008, Руководство администратора

Страница: 414 / 674

414 Novell ZENworks 7.2 Linux Management Administration Guide
n
ov
do
cx (e
n)
11
Ju
ly 20
08
You might want to copy your add-on images to the same location as the base image.
3 In the ZENworks Control Center, click Bundles , click the bundle containing the base image that
you want to associate the add-on images with, then click Details .
4 For the Add-On Image Files section, click Add .
5
Browse for and select an add-on image.
You can associate more than one add-on image with a base image. Repeat this step for each
add-on image.
6 Click Apply .
When a device boots that is assigned to this bundle, the add-on images are put down after the
base image in the order listed on this page.
Using a File Set of an Image
As explained in “Using Image Explorer to Customize an Image” on page 408 , you can exclude
individual files and folders from any of 10 possible file sets of an image.
Table 30-1
Image File Set Usages
30.1.3 Setting Up Disconnected Imaging Operations
Disconnected imaging operations are inherently manual. To perform a disconnected imaging
operation on a device, you must have a storage device to hold the image to be created or put down,
and that storage device must be locally accessible to the ZENworks Imaging Engine (in Linux)
when you boot the device from the imaging boot media.
The following sections explain how to set up and perform disconnected operations:
Š “Using a CD or DVD for Disconnected Imaging Operations” on page 415
Š
“Using a Hard Disk for Disconnected Imaging Operations” on page 416
Type of imaging
operation
How to specify the file set to use
Automatic
(Preboot
Services based
on default
settings) In the Multicast Wizard in the ZENworks Control Center, specify the number of the file
set in the
File set field. You must create the file set using the Image Explorer utility.
For more information, see Section D.1, “Image Explorer (imgexp.exe),” on page 591 .
You can create multiple Preboot bundles that point to the same base image, but to
different file sets of that image.
Manual
(command line or
menu) Use the
s
parameter on the
img restore
command. For example, to specify file set
number 3:
img restorel dellnt4.zmg s3
or
You can enter img at the bash prompt to display a menu, select Restore an image ,
then select Local image . Specify s fileset (for example, s3) in the Advanced
parameters field.
For details, see “ZENworks Imaging Engine Commands” on page 617 .