Novell Server Consolidation and Migration Toolkit 1.2, Руководство администратора

Страница: 60 / 130

60 Novell Server Consolidation and Migration Toolkit Administration Guide
no
vd
ocx
(e
n)
6 Ap
ril 20
07
NOTE: Because OES Linux does not support IPX, this section does not apply if you are
consolidating data to an OES Linux destination server.
6.11.1 Binding IPX on the Server
1 At the server console, enter
inetcfg
2 Select Boards, then press Enter.
3 Press Insert.
4 Select the appropriate network interface, then press Enter.
5 Specify a board name and slot number, then press Esc.
6 Select Yes to save changes, then press Enter.
7 To return to the main Internetworking Configuration screen, press Esc.
8 Select Protocols, then press Enter.
9 Select IPX, then press Enter.
10 Enable and configure IPX, then exit the INETCFG utility.
TIP: If you prefer, IPX can also be enabled on the server by adding the appropriate LOAD and
BIND commands to the server’s
autoexec.ncf
file.
6.11.2 Binding IPX on the Client
1 Access the Novell Client software and start the installation procedure.
2 Select the client version you want, then click Next .
3 Select the appropriate language, then click Next .
4 Select Custom, then click Next .
5 Select IP and IPX.
6 Click Next > Next > Finish .
6.11.3 Verifying IPX Is Bound on the Client
1 Right-click the red N on the status bar (system tray) on your workstation.
2 Select Novell Client Properties .
3 Click the Protocol Preferences tab.
If the Protocol window displays both IP and IPX, the client has IPX bound.
If the Protocol window displays only IP, then IPX needs to be bound on the workstation.
You can now proceed with your consolidation project.